Communication Information

The Communication Information is used to define both source and target systems that equipment will communicate with. When a piece of equipment is selected on the left hand side of the Client view the associated Communication Information will be displayed on the top half of the Equipment Detail.

​

• Related Articles

• MTConnect Communication as a Source

  DataXchange supports the MTConnect standard allowing the retrieval of equipment information from supported controls. A MTConnect enabled control can be setup as a Source for data with DataXchange.

• OPC UA Communication as a Source

  DataXchange supports OPC UA allowing the retrieval of machine information from supported OPC UA servers. An OPC UA enabled server can be setup as a Source of data within DataXchange.

• Using FOCAS in DataXchange

  Focas Communication as a Source Setting the Fanuc Focus communication as a source will be the most common configuration because this will acquire information about the control. Focas Communication as a Target DataXchange can be configured to send ...

• Using FOCAS in DataXchange

  Focas Communication as a Source Setting the Fanuc Focus communication as a source will be the most common configuration because this will acquire information about the control. Setting up Fanuc Focas as a Source is done by going to the DataXchange ...

• Using HAAS NGC in DataXchange

  DataXchange supports data collection directly from the HAAS NGC. A HAAS NGC enabled control can be setup as a Source for data within the DataXchange software Setting up HAAS NGC as a Source is done from the DataXchange tab, selecting the associated ...