MTConnect - DMG Mori CELOS

MTConnect - DMG Mori CELOS

MTConnect is installed on new DMG Mori machines as standard. On a Celos control it must be enabled for use manually. To do so, navigate to the CELOS Connector Management application on the CELOS screen and click Machine Data on the left side.


PDF Files of the documentation for the Celos Connector are attached here.

    • Related Articles

    • MTConnect Standard

      MTConnect is a protocol designed for the exchange of data between shop floor equipment and software applications used for monitoring and collecting data. MTConnect is not only a protocol, but a communication standard built around Internet ...

    • MTConnect Data Viewer

      The MTConnect Data Viewer is used to display the data stream values being returned from an MTConnect enabled machine. Data is refreshed every second when the viewer is connected. The MTConnect viewer can also be accessed through the connectivity tab ...

    • MTConnect Communication as a Source

      DataXchange supports the MTConnect standard allowing the retrieval of equipment information from supported controls. A MTConnect enabled control can be setup as a Source for data with DataXchange.

    • MTConnect - Okuma

      After installing the Okuma adapter and agent from the My Okuma store, the setting to Enable Monitoring tags is disabled by default. This needs to be checked in order to collect data. Also, by default all of the tags are enabled. If the machine is ...

    • Connectivity Tab

      The Connectivity Tab is only accessible when you are NOT logged into DataXchange. This tab contains functionality relative to testing the following connections: FOCAS Test View MTConnect Test View Scytec SRC with Ethernet (SRCE) Test View Scytec SRC ...