Fanuc Focas Viewer

The Fanuc Focas viewer allows users to connect to Focas systems directly from the DataXchange Client. This makes it easier to determine what data is coming from the control under different circumstances so expressions can be built around these situations.

• Related Articles

• Using FOCAS in DataXchange

  Focas Communication as a Source Setting the Fanuc Focus communication as a source will be the most common configuration because this will acquire information about the control. Focas Communication as a Target DataXchange can be configured to send ...

• Using FOCAS in DataXchange

  Focas Communication as a Source Setting the Fanuc Focus communication as a source will be the most common configuration because this will acquire information about the control. Setting up Fanuc Focas as a Source is done by going to the DataXchange ...

• Configuring the Fanuc 31i Control

  The Fanuc control must be configured in order for the communication to take place. The configuration consists of setting standard TCP/IP network properties. The steps to configure the control may vary from model to model. The following steps are for ...

• SRCE Viewer

  The SRCE Viewer connects to an SRCE from the DataXchange client for testing purposes. This can be accessed from the Connectivity tab when not logged, or from the DataXchange tab when connected to the DX Service.

• MTConnect Data Viewer

  The MTConnect Data Viewer is used to display the data stream values being returned from an MTConnect enabled machine. Data is refreshed every second when the viewer is connected. The MTConnect viewer can also be accessed through the connectivity tab ...