Scytec Knowledge Base | Knowledge Base

Recent Articles
Configure the Mazak API
Mazak has software on the NC system to control external access. Once the API has been installed on the NC external access must be configured to allow Scytec DataXchange to connect. Select the HOME button in the upper left of the NC screen. Select the ...
Heidenhain TNC - Checking Option 18 Status
Heidenhain controls require HEIDENHAIN DNC (Option 18) to be enabled in order to integrate with external software. To check if Option 18 is enabled, follow these steps. 1. Make sure the machine is in Programming (Edit) mode. 2. Press the MOD button. ...
Siemens - Finding the SINUMERIK Operate OPC UA Version
Press the ‘Machine’ button which is typically in the upper right corner. or Press the Diagnostics button which should be on the bottom or side of the screen Or Press the ‘Version’ button on the bottom of the screen Highlight the ‘System extensions’ ...
Siemens - Turn on OPCUA
Turning on OPC UA on a Siemens 840D Solution Line Make sure that you have the option "Access MyMachine /OPC UA 6FC5800-0AP67-0YB0" activated (Startup->Licenses). Note: if your machine is an embedded Siemens control with an overlay from another ...
SRCE - Network Instructions
Scytec SRCE IP Address Setup NOTE: PDF Download link at the bottom of the page Network Connectivity The Scytec Status Relay Controller Ethernet (SRCE) is Ethernet based and can be plugged into the network using a standard RJ-45 connection. It behaves ...

Popular Articles
MTConnect - DMG Mori CELOS
MTConnect is installed on new DMG Mori machines as standard. On a Celos control it must be enabled for use manually. To do so, navigate to the CELOS Connector Management application on the CELOS screen and click Machine Data on the left side. PDF ...
SRCE - Network Instructions
Scytec SRCE IP Address Setup NOTE: PDF Download link at the bottom of the page Network Connectivity The Scytec Status Relay Controller Ethernet (SRCE) is Ethernet based and can be plugged into the network using a standard RJ-45 connection. It behaves ...
Siemens - Finding the SINUMERIK Operate OPC UA Version
Press the ‘Machine’ button which is typically in the upper right corner. or Press the Diagnostics button which should be on the bottom or side of the screen Or Press the ‘Version’ button on the bottom of the screen Highlight the ‘System extensions’ ...
Heidenhain TNC - Checking Option 18 Status
Heidenhain controls require HEIDENHAIN DNC (Option 18) to be enabled in order to integrate with external software. To check if Option 18 is enabled, follow these steps. 1. Make sure the machine is in Programming (Edit) mode. 2. Press the MOD button. ...
How do I reset my password?
Your DataXchange password can either be reset from a web browser using the Data Display Application, if you have an email address defined in DataXchange. Otherwise your password can be reset from the DataXchange Windows Application by an ...

Knowledge Base